Engine Room Sound Insulation - Deluxe
1/2
$229.00
Bulk Pricing
Qty 1 - 3
$229.00 / Unit
Qty 4 - 9
$199.00 / Unit
Qty 10 +
$179.00 / Unit
Store
Choose a store for stock availability
Engine Room Sound Insulation - Deluxe
$229.00
This product, trade name Sorberbarrier AGC is a high efficiency noise absorbing product that does not require the use of other types of noise absorbers. In other words, it is an absorber and barrier in one.
Many polyurethane foams degrade over 5 to 7 years (“foam rot”) especially in hot environments. The foam in this product is engineered to resist this degradation. It is also superior to fibrous products which tend to fall apart in critical environments leaving not only a mess but noisy environment.
This product also has a ‘decoupling’ layer embedded about ¾ of the way through the foam which severely attenuates any noise - especially low frequency noise-– through to the outside cabins, etc.
Indeed, the MGA100 product only needs to be used on surfaces you want to stop noise passing through. This is significant because this is the material that you want to put between the noise source (Say an engine) and you and the passengers. To attenuate noise generally, you can use the less expensive MGA104.
The MGA100 has a barrier weight of 4.5kg/m2 and attenuates noise by 27dB – especially low frequencies.
The MGA100 has recently been improved. It now has a peel-and-stick layer on the back, avoiding messy spray glue. Make sure the surface you stick to is clean and grease-free.
This product is used on top quality Australian made boats like Riviera, Palm Beach Motor Yachts, Grand Banks, Malibu Boats, etc.
Finally, the product is faced with a hard-wearing (but flexible) dimpled aluminised facing surface which resists grease and oil. It can be wiped down with warm soapy cloth or Spray-n-Wipe, etc.
This product can be cut with a box-type cutter. If you keep the cut square you can butt pieces together and finish the seam with Gaffer or Silver tape. It can be screwed (with washers) or even nailed in place.
Size: The product has been specially cut for RTM. You can collect the product and it will fit the back seat of your car – 1m long x 650mm wide x 25mm thick. One sheet should be enough to do the critical walls of your engine compartment.
Full technical datasheet is available on request.
Dimensions: 1m(L) x 650mm(W) x 25mm(D)
Product Dimensions
Length
1.0 m
Width
650.0 mm
Depth
25.0 mm
Packaged Dimensions
Packaged Dimensions
130.0cm(Length) x 100.0cm(Width) x 2.5cm(Height)