These professional grade, high current solar charge controllers offer the flexibility to suit almost any solar installation. System voltage can be 12, 24 or 48V, and multiple units can be stacked together (up to 10 units max) allowing your system to grow and expand without rendering your old charge controller useless. Each unit features an LCD and front panel controls, and can be used as either a battery charger, load controller or diversion regulator. They can also be connected to a remote control for remote monitoring, and are fully protected against reverse polarity, short circuit, high temperature and overvoltage.
• System voltage: 12 - 48V
• Max solar voltage: 140V
• Max. operating voltage: 68V
• Parallel connection (x 10 units): Up to 600A
• Min. voltage to operate: 9V
• Power Consumption: 25mA while operating, 3mA when idle (inc. LCD)
• Cutout solar @ 90*C
• Cutout load @ 70*C
• Reconnect solar @ 70*C
• Reconnect load @ 50*C
• Humidity: 100% non-condensing with conformal coating on both sides of all PCBs
• Largest wire: 35mm^2 / 2GA
• Enclosure: type1, indoor rated
• Reverse polarity
• Short-circuit
• Over current
• Lightning and transient surge protection, using 4500W transient voltage suppressors
• High temperature protection via automatic current reduction or complete shut down
• Prevents reverse current from battery at night
NOTE: requires compatible 10pin data cable for parallel stacking or other communication connection
